Home>Bearing knowledge>Mechanical seals and application requirements

/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

Mechanical seals and application requirements

---

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Mechanical seals and application requirements summary: necessary conditions of the host conditions to select the appropriate type of mechanical seal data matching to ensure normal working life device mechanical seal parts bushing radial runout 0. 04mm rotor axial momentum 0. 1mm device machinery Seal stop seal housing positioning end face straight shaft 0. 04mm mechanical seal device necessary bushing seal cavity seal liquid dynamic pressure bearing common shaft shell shaft
1) It is necessary to select the appropriate type of mechanical seal and data matching according to the working conditions and the host condition; to ensure the normal operation and service life of the seal.
2) The radial runout of the shaft (sleeve) of the mechanical seal of the device shall be ≤0. 04mm; the axial yaw of the rotor is ≤0.11mm.
3) The sealed end cap (or housing) of the mechanical seal stop ring of the device; the straightness of the positioning end face to the shaft ≤ 0. 04mm.
4) When the mechanical seal is in the device; it is necessary to clean the shaft (sleeve bushing), the sealing cavity, the sealing end cap and the mechanical seal itself; to avoid any impurities entering the sealing part.
5) When the temperature of the transport medium is too high, too low, or rich in impurity particles, flammable, explosive, and toxic; it is necessary to refer to the relevant specifications of mechanical seals; adopt corresponding methods such as blocking, scouring, cooling, and over-consideration.
6) When mechanical sealing device; should be properly smooth. According to the product device instructions; to ensure the mechanical seal device scale.
7) It is necessary for the equipment to overflow the medium before work; to avoid the conflict and invalidate the seal.
8) The mechanical seal of the single spring transmission in the sample; the spring rotation should be reasonably selected; usually viewed from the end of the stop ring; when the shaft is turned clockwise; the right-hand spring should be selected. Otherwise, the left spring is selected.

---

Recommend to friends comments close window

Bearing related knowledge

Bearing oil bearing terminology in English and -6 Skill analysis: What is the protection and maintenance of the rolling mill bearing? Cold treatment of bearing rings

This article links to http://
Please indicate China Bearing Network http://

Previous:Analysis of Silencing Smooth Grease Next: Why is smooth grease lost in use?